Controller Programming; Programming Menu - TechWind SDK-500 User Manual

4. CONTROLLER PROGRAMMING

The programming menu allows the installer to set all parameters of controller operations.
The meaning of the particular parameters is described in chapter MENU DESCRIPTION.
•
Be sure to read First power-on section before first powering the SDK-500!
• Entering the menu is achieved by pressing and holding for 3 seconds
[ESC/MENU] button. In case the password was entered (see Access pass.
description at page 25), the first message will be "Enter Password" message.
Entering the programming menu stops the motor.

4.1. PROGRAMMING MENU

To enter main menu operator must to press and hold at least 3 sec. [ESC/MENU] button.
If the user password is defined (see parameter „Access pass." , menu „ Access setup "),
operator have to enter correct one before proceeding to menu options. Entering of the
passwords is similar to the edition of numeric parameters. After entering of last digit of the
password first menu position will be displayed (if the password is correct) or "Wrong
password! " message otherwise.
Functions of the buttons while sub-menu and parameters choice:
Buttons [<] [>] allows to choose particular menu option and change value of
selected parameter. Display shows the name of selected item or its value.
Functionality of [ENTER] button depends on present menu position:
ENTER
• If selected menu position is a parameter, pressing this button allows to
• If selected menu position is a sub-menu, pressing this button will enter the
• The [ESC/MENU] button allows to leave current sub-menu and abandon
ESC
MENU
• Pressing and holding down [MENU/ESC] for 3 seconds in normal state of
User's manual for
edit its value.
sub-menu and show the first of its options.
changes. If pressed in the main menu it will make SDK-500 exit the
programming mode and resume normal operation.
the controller to enter the programming menu.
elevator door controller SDK-500
15