Radware Alteon Installation And Maintenance Manual page 9

GROUNDING
Before connecting this device to the power line, the protective earth terminal screws of this device
must be connected to the protective earth in the building installation.
LASER
This equipment is a Class 1 Laser Product in accordance with IEC60825 - 1: 1993 + A1:1997 +
A2:2001 Standard.
FUSES
Make sure that only fuses with the required rated current and of the specified type are used for
replacement. The use of repaired fuses and the short-circuiting of fuse holders must be avoided.
Whenever it is likely that the protection offered by fuses has been impaired, the instrument must be
made inoperative and be secured against any unintended operation.
LINE VOLTAGE
Before connecting this instrument to the power line, make sure the voltage of the power source
matches the requirements of the instrument. Refer to the Specifications for information about the
correct power rating for the device.
48V DC-powered platforms have an input tolerance of 36-72V DC.
SPECIFICATION CHANGES
Specifications are subject to change without notice.
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device pursuant to Part 15B of the FCC Rules and EN55022 Class A, EN 55024; EN
61000-3-2; EN 61000-3-3; IEC 61000 4-2 to 4-6, IEC 61000 4-8 and IEC 61000-4-
11For CE MARK Compliance. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user is required
to correct the interference at his own expense.
VCCI ELECTROMAGNETIC-INTERFERENCE STATEMENTS
Figure 3: Statement for Class A VCCI-certified Equipment
Translation of Statement for Class A VCCI-certified
This is a Class A product based on the standard of the Voluntary Control Council for Interference by
Information Technology Equipment (VCCI). If this equipment is used in a domestic environment,
radio disturbance may occur, in which case, the user may be required to take corrective action.
Document ID: RDWR-ALOS-V2815_IG0203
Radware Alteon Installation and Maintenance Guide
Equipment:
9