Radware Alteon Installation And Maintenance Manual page 60

Radware Alteon Installation and Maintenance Guide
Initial Configuration
Deploying Alteon VA for VMware Only
To deploy Alteon VA for VMware
1. Login to the vSphere client interface.
2. From the Home > Inventory drop-down menu, select Templates and VMs.
3. Right-click the desired Alteon VA from the list, and then select Open Console.
Note: To exit the console (release the cursor), click CTRL+ALT.
Deploying Alteon VA for All Environments
To deploy Alteon VA for all environments
1. To get the management IP address, do one of the following:
— In the vSphere interface, click the Summary tab of your defined Alteon VA to view the IP
address of the management network.
— In the Alteon VA console, enter /info/sys/mgmt.
2. To disable the DHCP, enter /cfg/sys/mmgmt/dhcp disable, and configure the management
network manually using the CLI as follows:
a. To configure the IP address, enter /cfg/sys/mmgmt/addr ip address
b. To configure the mask, enter /cfg/sys/mmgmt/mask mask
c. To configure the gateway, enter cfg/sys/mmgmt/gw default gw
d. To enable the configuration, enter /cfg/sys/mmgmt/ena
3. Enable the management interface access, as follows:
— To configure Telnet, enter /cfg/sys/access/tnet e
— To configure SSH, enter /cfg/sys/access/ssh/on
— To configure HTTP, enter /cfg/sys/access/http/e
4. To apply the configuration, enter apply.
60
Document ID: RDWR-ALOS-V2815_IG0203