Radware Alteon Installation And Maintenance Manual page 30

Radware Alteon Installation and Maintenance Guide
Alteon Application Switch Platforms
Table 3: Alteon Application Switch 4416 Front Panel
Feature Label/Description
Status LEDs:
• PWR—green indicates nominal operation. When the platform carries a dual
power supply, red indicates that one of the two power cables is not
supplying power or that one of the power supplies is malfunctioning. When
the LED is red, a qualified service person should immediately check the
power source and the power supply.
• FAN—green indicates nominal operation. Red indicates that one or more
fans is not operating.
• SYS OK—green indicates nominal operation. Red indicates that the device is
booting. Red or alternating red and green indicates a warning (for example,
the temperature is high, but still in the allowed range).
Figure 5: Alteon Application Switch 4416 (with Single Power Supply) Back Panel
Figure 6: Alteon Application Switch 4416 (with Dual Power Supply) Back Panel
Table 4: Alteon Application Switch 4416 Series Back Panel
Feature
Power supply socket(s)
CompactFlash
Ground screws
Notes
>> If the power is disconnected and reconnected (for example, after the power cord is
removed and replaced, or after a power failure), the platform returns to its previous
state. For example, if the platform was running, and then you disconnect the power
cord, when you reconnect the power cord, the platform automatically switches on.
Likewise, if the platform is not running, if you disconnect the power cord and reconnect
it, the platform stays powered off until you press the power button.
>> For additional technical information, see
30
Description
The socket to which the power cable is connected.
Insertion point for CompactFlash card.
Screws to ground the platform chassis to the rack. 1U units have one
ground screw. Typically, 2U units have two ground screws.
Appendix A - Specifications, page
Document ID: RDWR-ALOS-V2815_IG0203
77.