Table of Contents
Advertisement
Main Level
Back Light
Fixture Hours
Information
Version
Reset
Factory
Configuration (DMX)
Use control configurations to operate the product with a DMX controller.
Control Personalities
This setting allows you to choose a particular control personality.
1.
Go to the DMX Personality main level.
2.
Select the desired personality (see table below).
•
See the
personality.
•
Make sure that the starting addresses on the various products do not overlap due to the
new personality setting.
Starting Address
Each product will respond to a unique starting address from the DMX controller. All products with the same
starting address will respond in unison.
1.
Go to the DMX Address main level.
2.
Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
Page 8 of 15
Programming Levels
On
10S
20S
30S
<_ _ _ _H>
<V_._>
UID
<_ _ _ _ _ _ _ _>
No
Yes
Personality
1Ch: 8bit Dim
2Ch: 16bit Dim
2Ch: 8bit Dim+Zoom
5Ch: 16bit-Full
Starting Address
section for the highest starting address you can select for each
Personality
1Ch: 8bit Dim
2Ch: 16bit Dim
2Ch: 8bit Dim+Zoom
5Ch: 16bit-Full
Description
Display backlight always on
Turns off display backlight after 10
seconds of inactivity
Turns off display backlight after 20
seconds of inactivity
Turns off display backlight after 30
seconds of inactivity
Shows total hours the product has been on
Shows current firmware version
Shows product UID
Resets the product to factory default
settings
Channels
1
2
2
5
Address
512
511
511
508
Ovation F-265WW User Manual Rev. 1
Operation
Advertisement
Table of Contents
