Scanning Safety - Planmeca PlanScan User Manual

Planmeca
3

Scanning Safety

Warning:
Failure to adhere to all safety warnings may result in personal injury, equipment damage, or
data loss.
Do not use the Planmeca products for any purpose other than its intended and labeled use.
To prevent electrical shock, do not open any sealed or user restricted access panels or connectors.
In case of emergency unplug the computer power cord from the wall or from the computer.
Do not make any unauthorized repairs or modifications to the system software or hardware. This includes
installing unauthorized software on the host computer system or altering or bypassing any safety
switches or mechanisms. Changes or modifications not expressly approved by Planmecacould void the
user's authority to operate the equipment and/or void the warranty.
Do not install or operate the Planmeca products in an environment where an explosion hazard exists, e.g.,
high oxygen area.
Comply with all applicable regulations when disposing of waste materials from the Planmeca products.
Do not attach any equipment or devices to the Planmeca products unless their use has been specifically
authorized by Planmeca or E4D Technologies.
Medical electrical equipment requires special precautions regarding EMC (Electromagnetic Compatibility).
The Planmeca products must be installed and placed into service according to the EMC information
provided in the documentation that accompanies the Planmeca products.
Portable and mobile RF (Radio Frequency) communications equipment can affect medical electrical
equipment.
The wireless components in the Planmeca products may be interfered with by other equipment,
even if the other equipment is fully compliant with CISPR (International Special Committee on Radio
Interference) emission requirements.
When possible, electrical equipment should not be used when adjacent to other electrical equipment.
If adjacent use is necessary, the equipment should be observed to verify normal operation in the
configuration in which it will be used.
When connecting the Planmeca components, use only the cables supplied with the products.
Failure to do so may result in increased electromagnetic emissions or reduced immunity to external
electromagnetic emissions.
If you suspect equipment malfunction or failure, discontinue using the Planmeca products and contact
Technical Support immediately. Do not attempt to make any repairs on the Planmeca products.
Read and comply with all safety, warning, and instructional labels on the Planmeca products.
Avoid eye exposure while using the color tip. LEDs contained in this device pulse at a frequency that may
elicit reactions in sensitive individuals. These reactions may include seizures.
16 Scanning Safety Planmeca PlanScan User Manual