Turn On Laptop; Opening Romexis; Scanner; Removable Components - Planmeca PlanScan User Manual

Turn ON Laptop

Press the power button to start the laptop.
The Windows 8 Start screen appears. On your keyboard, press the
standard desktop appear if desired.

Opening Romexis

Click the Romexis icon on your desktop to open the software.

Scanner

Removable Components

The PlanScan system has a set of removable components.
Connecting the Thunderbolt™ Adapter
Properly connecting and disconnecting the scanner prevents damage to your devices.
1
Insert the Thunderbolt adapter into the adapter slot on the side of the
laptop. (The adapter should remain attached, even when not in use.)
2
After opening the Scan tab, connect the red FireWire connector of the
scanner into the white Thunderbolt™ adapter.
The laptop gives an audible signal to confirm that the connection is fully
seated.
To remove the scanner, hold the red end with one hand and with
the other hand grasp the Thunderbolt adapter. Gently pull apart to
disconnect. Leave the white Thunderbolt adapter attached to the
computer.
Disconnecting the Thunderbolt™ Adapter
If you wish to remove the adapter from the laptop:
1 Disconnect the scanner and exit Romexis to the Windows desktop.
2 Navigate to the Eject Media icon in the lower left corner of the desktop.
3 Click the icon and choose Eject IEEE 1394 Controller.
4 Remove the Thunderbolt adapter from the laptop.
10828200.B
Note: Failure to follow this procedure may result in an inoperable scanner.
For additional questions or concerns please contact Customer Support at
800.537.6700.
key to make the
Introduction 7