Rotating The Models - Planmeca PlanScan User Manual

To align models, drag and drop the buccal bite, pre-op, or bite registration over the prep model.
The models will snap into place or will return to their original positions.
In Buccal/Opposing cases, the opposing model appears after the prep and buccal bite are
aligned. Click and drag the opposing model to match the buccal bite model.
To access the menu options at the top or to return to scanning, deactivate the selected
Alignment icon. You cannot proceed if the Alignment icon is active (orange).

Rotating the Models

When necessary to aid in alignment, you can rotate the buccal bite or opposing model.
Note: The preparation model cannot be rotated, it is always stationary.
With the mouse cursor directly over the buccal or opposing model, right click and drag to
rotate.
With the mouse cursor on the background, right click and drag to rotate all of the models at the
same time.
Left click and drag to move the models on the screen.
Once the models are in good position in relation to each other, use the steps in the previous
section to align the models.
10828200.B Scanning 33