Table of Contents
Advertisement
KMB 18 & 28 MANUAL
DANGER: Use only the bolts pro-
vided with the Weld Lens Kit for installa-
tion of the assembly. Longer bolts will
damage the mask frame and/or the
threaded inserts. This could cause flood-
ing through the port.
7.5 USE OF QUICK-DISCONNECT
A quick-disconnect should be used with all bail-
out systems. They are available through all
KMDSI dealers. It provides greater convenience
on deck while dressing the diver. It also makes it
possible to separate the attachment of the bailout
from the mask should the diver become entangled
underwater.
The quick-disconnect is designed to be installed
in any low pressure port of the diver's bailout
regulator. The connector splits the hose into two
halves, with a male and female connector on each
end. The female connector is equipped with a
sleeve lock that must be properly aligned before
the hose can be disengaged.
One end of the connector is designed to be at-
tached to the auxiliary valve assembly (103),
while the other end of the connector is designed
to attach to any of the standard low pressure ports
on the KMDSI SuperFlow first stage regulator
(or any high performance regulator) used for the
bailout supply.
Fig. 7.8 A quick disconnect will make it simpler to hook up
your bail-out to your mask.
page 88
© Copyright 1970-2003 Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 010518001
7.6 MASK CARRYING BAG
To help protect your Kirby Morgan Band Mask
the mask carrying bag should be used to transport
and store your mask between jobs. The KMDSI
bag is made from extra heavy duty, black, ripstop
nylon. The bottom of the bag is padded for
additional protection. Grommeted drain holes
allow the bag to breathe. The bag is also equipped
with large carrying straps and side pockets. The
bag is not intended for shipping your mask as air
cargo. The part number for the bag is KMDSI
Part #500-901.
Fig. 7.9 To help protect your mask during travel, use the
mask carrying bag.
Hide quick links:
Advertisement
Table of Contents
