Net Option Mode Configure - D-Link DWC-1000 Reference Manual

Wireless controller
Hide thumbs Also See for DWC-1000:
Table of Contents

Advertisement

Wireless Controller
japanese_pppoe
125
secondary_profile
primary_dns
japanese_pppoe
126
secondary_profile
secondary_dns
japanese_pppoe
127
secondary_profile
get_ip_from_isp
japanese_pppoe
128
secondary_profile
static_ip
japanese_pppoe
129
secondary_profile
subnet_mask
japanese_pppoe
130
mac_type
japanese_pppoe
131
mac_address
12.27

net Option mode configure

S.No Com mand Nam e
1
save
2
cancel
3
exit
4
Option_mode_type
5
loadbalancing
6
loadbalancing algo
loadbalancing
7
failover_method
8
loadbalancing spillover
loadbalancing spillover
9
load_tolerance
loadbalancing spillover
10
max_bandw idth
loadbalancing
11
failover_method type
loadbalancing
12
failover_method dns
loadbalancing
13
failover_method dns
ipaddr_Option1
Enter No and give valid static dns addresses
Valid primary DNS Server IP Address
Valid secondary DNS Server IP Address
Enter Yes to get IP dynamically from ISP if you have
not been assigned any static IP address. The ISP w ill
automatically assign an IP address to the router
using PPPOE netw ork protocol. Otherwise Enter No
and give valid static IP address
Valid IP Address
Valid subnet mask
Select the Mac Address Source
enter Valid MAC address
Description
Save Option mode configuration changes.
Roll back ipv4 Option configuration changes.
Save Option mode configuration changes and current
mode.
Select among the options: SINGLE_OPTION,
LOAD_BALANCING, AUTO_ROLLOVER
If Mode Type selected is LOAD_BALANCING, this
field gives you options to configure
LOAD_BALANCING credentials
Enter the type of LoadBalancing Algo
Select the Fail Over detection method
Spill Over Configuration Parameters
Percentage of max bandw idth after which the router
sw itches to secondary OPTION
Sets the maximum bandw idth tolerable by the
Primary OPTION.If the bandw idth goes below the
load tolerance value of configured Max Bandw idth,
the router sw itches to secondary OPTION.
Select the Fail Over detection method
94
CLI Reference Guide
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
Boolean choice
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
Types of mac address source
MAC address
AA:BB:CC:DD:EE:FF w here each
part is in the range 00-FF
Type and Description
Types of OPTION modes
Types of Loadbalancing algorithms
Unsigned integer
Unsigned integer
Types of Faillover Detection
methods
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DWC-1000 and is the answer not in the manual?

Table of Contents