Net Routing Ospfv2 Configure <Ltinterface - D-Link DWC-1000 Reference Manual

Wireless Controller
13 static secondary_dns Set ipv6 secondary dns address
14 pppoe pppoe over ipv6 configuration parameters
15 pppoe username Enter the username to authenticate
16 pppoe password Enter the passw ord to authenticate
17 pppoe authOpt Enter the Auth Option to authenticate
Enter the dhcpv6 option for configuring additional
18 pppoe dhcpv6_opt
parameters.
19 pppoe primary_dns Valid primary DNS Server IP Address
20 pppoe secondary_dns Valid secondary DNS Server IP Address
12.32 net routing ospfv2 configure
<ltinterface>
S.No Com mand Nam e Description
1 <ltinterface> ospfv2 configuration mode.
2 save Save OSPFv2 configuration changes.
Save OSPFv2 configuration changes and exit current
3 exit
mode.
4 cancel Roll back configuration changes.
5 enable Enable/Disable OSPFv2 for a particular interface.
6 area Give the area to w hich the interface belongs
Helps to determine the OSPFv2 designated router for a
netw ork.The router with the highest priority w ill be more
7 priority eligible to become Designated Router. Setting the value
to 0, makes the router ineligible to be come Designated
Router. The default value is 1.
The number of seconds for HelloInterval timer
value.Setting this value, Hello packet w ill be sent every
8 hello_interval timer value seconds on the specified interface. This value
must be the same for all routers attached to a common
netw ork. The default value is 10 seconds.
The number of seconds that a deviceb
must not have been seen before its neighbors declare
9 dead_interval the OSPF router dow n.This value must be the same for
all routers attached to a common netw ork.The default
value is 40 seconds.
10 cost The cost of sending a packet on an OSPFv2 interface
Give the authentication type used for OSPFv2.If
11 auth_type Authentication type is none the interface does not
authenticate ospf packets.If Authentication Type is
bcd:abcd w here each part is in the
range [0-9A-Fa-f:]
IP address
abcd:abcd:abcd:abcd:abcd:abcd:a
bcd:abcd w here each part is in the
range [0-9A-Fa-f:]
String
String
PPPOE Authentication Types.
OPTION interface type
IP address
abcd:abcd:abcd:abcd:abcd:abcd:a
bcd:abcd w here each part is in the
range [0-9A-Fa-f:]
IP address
abcd:abcd:abcd:abcd:abcd:abcd:a
bcd:abcd w here each part is in the
range [0-9A-Fa-f:]
Type and Description
Boolean choice
Unsigned integer
Unsigned integer
Unsigned integer
s hello packets
Unsigned integer
Unsigned integer
OSPF Authentication type
98
CLI Reference Guide