Net Routing Ospfv3 Configure <Ltinterface; Net Port Management Configure <Ltportname - D-Link DWC-1000 Reference Manual

Wireless Controller
Simple then ospf packets are authenticated using simple
text key.If Authentication Type is MD5 then the interface
authenticates ospf packets with MD5 authentication.
12 auth_key Text Key for Simple Authentication type
13 md5_key_id Give MD5 Key id
14 md5_auth_key Give MD5 text key
12.33 net routing ospfv3 configure
<ltinterface>
S.No Com mand Nam e Description
1 <ltinterface> ospfv3 configuration mode.
2 save Save OSPFv3 configuration changes.
3 exit Save OSPFv3 configuration changes and exit current mode.
4 cancel Roll back configuration changes.
5 enable Enable/Disable OSPFv3 for a particular interface.
Helps to determine the OSPFv3 designated router for a
netw ork.The router with the highest priority w ill be more
6 priority eligible to become Designated Router. Setting the value to 0,
makes the router ineligible to beco me Designated Router.
The default value is 1.
The number of seconds for HelloInterval timer value.Setting
this value, Hello packet w ill be sent every timer value
7 hello_interval seconds on the specified interface. This value must be the
same for all routers attached to a common netw ork. The
default value is 10 seconds.
The number of seconds that a deviceb
must not have been seen before its neighbors declare the
8 dead_interval OSPF router dow n.This value must be the same for all
routers attached to a common netw ork.The defaul t value is
40 seconds.
9 cost The cost of sending a packet on an OSPFv3 interface
12.34 net port management configure
<ltportName>
S.No Com mand Nam e Description
1 <ltportName> port management configuration mode.
2 save Save port management configuration changes.
Save port management configuration changes and exit
3 exit
current mode.
4 cancel Roll back port management configuration changes.
5 enable Enable/Disable the port status
auto_negotiation_ena Select this to let the gatew ay and network to determine the
6
ble optimal port settings.
Choose betw een Half Duplex and Full Duplex based on the
7 duplex_mode
port support. The default is Full Duplex for all ports.
One of three port speeds can be selected: 10 Mbps, 100
8 speed Mbps and 1000 Mbps (i.e. 1 Gbps). The default setting is
1000 Mbps for all ports
String
Unsigned integer
String
Type and Description
s hello packets
99
CLI Reference Guide
Boolean choice
Unsigned integer
Unsigned integer
Unsigned integer
Unsigned integer
Type and Description
Port name
Boolean choice
Boolean choice
select the duplex mode
select the speed