Configure Quality Of Service Settings - TRENDnet TEW-823DRU User Manual

TRENDnet User's Guide

Configure Quality of Service Settings

Advanced > Setup > QoS
QoS involves prioritization of network traffic. QoS can be targeted at a network interface,
toward a given server or router's performance, or in terms of specific applications.
1
Log into your router management page (refer to
2
Click on Advanced > Setup > QoS.
3
In QoS Setting section, modify the following settings:
ͫ Enable QoS: Click Enabled to allow the Quality of service through the router. You can
also click Disable to disable the Quality of service through the router.
ͫ Prioritize ACK: Click Enabled to prioritize the acknowledgment packets.
ͫ Prioritize ICMP: Click Enabled to prioritize the ICMP requests. You can also click
Disabled if you do not want to prioritize the ICMP requests.
ÍNote: The ICMP requests are basically ping requests. It is recommended to disable
it unless you wish to run a game server where it is important to maintain low level
of ping for players to determine the latency.
4
In Traffic Class Setting section, click the Default Traffic Class drop-down list and select the
traffic class you would like to configure for the QoS rule.
© Copyright 2014 TRENDnet. All Rights Reserved.
"Log in to Management Page" on page
5
In Inbound Class Setting section, modify the following settings:
ͫ BW Max Inbound: Enter the maximum download speed of your ISP (Internet Service
Provider).
ͫ Highest/High/Medium/Low/Lowest: Enter the download speeds you would like to
apply on each state of download speeds. This setting is similar to setting the priority
speeds of each class.
8).
TEW-823DRU
38