TRENDnet User's Guide
5
You can choose to set the device time and date automatically synchronize with the
Internet Time Server or manually set the time. Do one of the following:
ͫ Enable NTP Server: Check to enable the NTP server option. This option lets you to
synchronize the time and date in router with an NTP (Network Time Protocol) server.
ͫ NTP Server: Enter the NTP server address. For example, pool.ntp.org.
ͫ Time Zone: Click to select the time zone from the drop-down list.
ͫ NTP synchronization: Change the NTP synchronization period.
ͫ You can set the router's time and date manually in Date and Time Settings section.
Time is specified in 24-hour format.
ÍNote:
6
Click Apply to save the changes.
To discard the changes, click Cancel.
ÍNote:
© Copyright 2014 TRENDnet. All Rights Reserved.
Backup System Settings
Advanced > Administrator > Settings Management
This option allows you to backup your access point configuration.
1
Log into your router management page (refer to
2
Click on Advanced > Administrator > Settings Management.
3
In Export Settings section, click Export.
ÍNote:
Depending on your web browser settings, you may be prompted to save a
file (specify the location) or the file may be downloaded automatically to the web
browser settings default download folder. An example filename, TEW-823DRU_
config.bin.
Load System Settings
Advanced > Administrator > Settings Management
This option allows you to load the system settings after the firmware upgrade or reset to
factory defaults.
1
Log into your router management page (refer to
2
Click on Advanced > Administrator > Settings Management.
3
In Import Settings section, click Browse to load the settings file.
4
A separate file navigation window should open.
5
Select the router configuration file to restore and click Import. The default filename is
TEW-823DRU_config.bin. If prompted, click Yes or OK.
6
Wait for the router to restore the settings.
TEW-823DRU
"Log in to Management Page" on page
"Log in to Management Page" on page
8).
8).
43