Fluke Endurance 1RL Operating Instructions Manual page 26

Installation
•
•
•
5.2.3.2 M12 4-Conductor shielded cable
The 4-conductor shielded connecting cable is used to link the Endurance 1R device to a LAN/Ethernet
device. A standardized cable, equipped with a M12 4-pin connector type, D-coded, suited for
industrial Ethernet with IP67 protection rate and a screw retention feature on one side and a RJ45
connector type on the counter side is used. Via the 4-conductor cable the Endurance 1R device can also
be powered as a PD (Powered Device) by a PSE (Power Sourcing Equipment) in a PoE (Power over
Ethernet) mode. Refer to PoE standard IEEE 802.3af, mode A, 10/100 Mbit mixed DC & data.
Figure 16: M12 4-Conductor shielded cable with RJ45 on counter side
5.2.3.3 Endurance 1R specific terminal block
To connect the Endurance 1R device via the 12-conductor shielded cable to the industrial process
world, an Endurance 1R specific terminal block is available. Attach the color coded sensor cable wires
to the color coded side of the terminal block.
26
info@Raytek-Direct.ca
Longer cables are available from the factory.
Limit power cables to 60 m (200 ft) or less. RS485 cables can be extended up to
1200 m (4000 ft).
Avoid installing the sensor cable in noisy electrical environments such as
around electrical motors, switch gear, or induction heaters.
Figure 17: Endurance 1R labeled terminal block
Rev. E1 Sep 2015
ENDURANCE 1R
1.800.868.7495