Speed / Relative Centrifugal Force (Rcf); Runtime - Sigma 3-16KL Operating Manual

Pos: 131 /10 0 Sigm a/10 0 BA Z entrif uge n Sigm a (Sta nda rd mod ule)/ 060 B etrie b_Spinc ont rol L +S/Spinco ntr ol L (Ze nt6 )06 0-0 030 -00 20- 0050 Dr ehza hl/RZB @ 27\ mod _14 053 192 606 46_6 8.d ocx @ 192 717 @ 4 @ 1
6.3.2.1

Speed / relative centrifugal force (RCF)

Pos: 132 /01 0 Univ ersal mod ule/L eerz eile @ 0\m od_ 120 211 624 450 0_0. docx @ 11 4 @ @ 1
Pos: 133 /10 0 Sigm a/10 0 BA Z entrif uge n Sigm a (Sta nda rd mod ule)/ 060 B etrie b_Spinc ont rol L +S/Spinco ntr ol L (Ze nt6 )06 0-0 030 -00 20- 0060 L aufzei t @ 2 7\m od_ 140 531 9263 257 _68 .docx @ 1 9274 5 @ 4 @ 1
6.3.2.2

Runtime

NOTE
Version 03/2014, Rev. 2.6 of 06/11/2015 • sb
Translation of the original operating manual, part no. 07050
The set speed of the centrifuge is displayed in the upper area of the
Speed/RCF field. The actual value is displayed right below. The speed is
stated as the number of revolutions per minute (min
values as a multiple of the gravitational acceleration (x g). The values are
interdependent (see chapter 2.2.2.1 - "Speed, radius, and relative
centrifugal force"). The maximum speed/RCF values depend on the rotor
that is used.
The parameters speed and RCF can be changed during the centrifugation.
Fig. 11: Setting the speed value or the RCF value
The set runtime is displayed in the upper section of this field, with the
remaining runtime shown below. The runtime is counted down from the set
value, starting with the start of the centrifuge and ending with the start of
the deceleration phase. The maximum runtime is 99 h:59 min:59 sec. As of
59 min:59 sec, the unit switches from "h:min" to "min:s".
The parameter runtime can be changed during the centrifugation.
If the runtime is changed during an active centrifugation run, the time that
has already elapsed will not be taken into consideration. The centrifuge will
perform a complete run with the new runtime.
Fig. 12: Setting the runtime, here in the time unit "min:s"
Refrigerated Centrifuge Sigma 3-16KL
Refrigerated Centrifuge Sigma 3-16KL IVD
6 Using the centrifuge
-1
= rpm) and the RCF
33