AnyTone AT-D868UV Operating Manual page 17

2.1 Programmed Key
In PC software – Public - Optional Setting - Key function, it is possible
to set different functions for PF1, PF2, PF3, P1, P2 keys.
OFF No Function
Voltage Check the current battery capacity voltage
Switch the power between super high, high, middle and low
Power
power.
Repeater Switch between talk around and repeater mode
Reverse Turn on/off the frequency reverse function.
Digital
Choose the encryption group
Encryption
In Analog mode, send the DTMF/5TONE/2TONE encode. This
Call
function is only valid for analog channel.
In Analog mode, send the tone pulse frequency signal to active
TBST
the repeater.
VOX Set up the VOX level
VFO/MR Switch between VFO mode and memory channel mode.
Sub PTT Sub channel PTT, press to start the call on sub channel
Scan Scan on/off
FM Radio FM radio on/off
Long press the key to start alarm, short press again to exit the
Alarm
alarm.
Record switch Enable/disable the recording function
Start/stop recording. When stop recording, the radio will remind
Record
repeat or send the record.
SMS In digital mode, press to enter into messages
Dial Start the manually dial
GPS Check the GPS position information
Monitor Monitor the weak signal or the signal with unmatched ID.
Main channel
Choose channel A or channel B as the main channel
switch
Press the key to perform the programmed function in hot key
Hot key 1~6
setup
Alone Turn on/off the work alone function.
11
AT-D868UV Digital DMR and Analog UHF/VHF Two Way Radio