Table of Contents
Advertisement
To replace the component, reverse the removal procedure.
Removing and replacing the 10SFF drive backplane
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any system installation. Improper grounding can cause electrostatic discharge.
Procedure
1. Back up all server data.
2. Power down the server.
3. Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack .
4. Remove the access panel.
5. Remove all drives and drive blanks.
Note where each drive is located.
6. Disconnect all cables from the drive backplane.
7. Remove the drive backplane.
Removing and replacing the 10SFF drive backplane
71
Advertisement
Table of Contents
