Removing And Replacing The 8Sff Drive Backplane - HP ProLiant DL360 Gen10 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing the 8SFF drive backplane

Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
4. Remove the access panel.
5. Remove all drives and drive blanks.
Note where each drive is located.
6. Disconnect and remove all cables from the drive backplane.
7. Remove the drive backplane.
70 Removing and replacing the 8SFF drive backplane