Removing And Replacing A Gpu In The Primary Riser - HP ProLiant DL360 Gen10 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing a GPU in the primary riser

Procedure
1. Observe the following warning:
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
5. Remove the access panel.
6. Remove the riser cage.
7. If needed, disconnect the GPU power cable and then remove the GPU from the riser.
50 Removing and replacing a GPU in the primary riser