Table of Contents
Advertisement
dCS Vivaldi Upsampler Plus User Manual
Software Issue 2.0x
November 2016
STEP 6 - Using the Vivaldi 2.0 app as a remote control
You can use the app to change inputs or settings by tapping the Home page's Upsampler Inputs,
DAC Inputs and Configuration pads. Commands are sent to the DAC are sent via the
AES3
interface.
In order to control the Transport and read information from the DAC, it is necessary to fit the 3-way
RS232 cable (supplied with the Upsampler Plus) to the system as shown below. Note that the 3
connectors are labelled VTT (for the Transport), VPP (for the Upsampler) and VDC (for the DAC),
each must be fitted to the correct unit.
The
Settings > RS232 Mode
menu page on all 3 units must be set to Binary.
Page 26
Vivaldi Upsampler Manual v2_0x
English version
Advertisement
Table of Contents
