Installation Instructions - Belling PBi60 Installation And User Instructions Manual

This appliance conforms to the European Directive EC/2002/96, Waste Electrical and
Electronic Equipment (WEEE). By making sure that this appliance is disposed of in a
suitable manner, the user is helping to prevent potential damage to the environment or
to public health.
The symbol on the product or on the accompanying paperwork indicates that the
appliance should not be treated as domestic waste, but should be delivered to a
suitable electric and electronic appliance recycling collection point.
Follow local guidelines when disposing of waste. For more information on the treat-
ment, re-use and recycling of this product, please contact your local authority, domes-
tic waste collection service or the shop where the appliance was purchased.

INSTALLATION INSTRUCTIONS

! ! !
We recommend that when you install this appliance - a minimum 17mm gap between hob base and
appliance must be maintained.
These instructions address specialised installers and serve as a guide for installation,
adjustment and maintenance in conformity with the laws and regulations in force.
We recommend that this appliance is connected by a competent person, who is a mem-
ber of a recognised "Competent Persons Scheme" and who will comply with the I.E.E. and
local regulations.
The appliance must be installed using a multi-pole control unit of 30 Ampere minimum
capacity with 3mm minimum separation at all poles.
Ensure that you route all mains electrical cables well clear of any adjacent heat source,
such as an oven or grill.
Where a fixed connection is used, a device allowing the appliance to be isolated on all
G
poles from the mains supply with a contact opening width of at least 3mm must be
provided.
After connection to the electricity please check that all electrical parts are working.
G
The maximum power rating is specified in the Technical Data section of this hand-
G
book, and also on the Data Badge on the appliance.
POSITIONING (fig.3)
The appliance is made for fixing into a worktop, as shown in the relevant figure. Apply
the supplied sealant to the entire perimeter of the hob and insert it into the cutout hole
(for sizing see fig. 3B). Fix the appliance into the worktop with the 4 stays, rotating
them according to the depth of the work top. If the underside of the appliance will be
accessible after installation, a separator panel G (fig. 6A) will need to be mounted
maintaining the distances shown (fig. 6B). If the appliance is installed over an oven the
panel is not necessary (fig. 7A - 7B).
IMPORTANT: if there is an oven under the induction hob it is advisable for it to have
a cooling fan. Do not use the induction hob while PYROLITIC cleaning is in process.
WARNING: to allow the circulation of as much fresh air as necessary, there must be
at least 17 mm between the induction hob module and any appliance installed under
it (fig. 7B). In any event, adequate aeration must be provided.
To allow fresh air circulation there must be openings in the kitchen furniture (fig. 6A-
7A) of the sizes indicated in fig. 6B-7B.
10