Belling IH60 Users Manual & Installation Handbook page 6

Hob safety
1) Parts of the appliance may become
hot while in use. Always make sure that
children are supervised when they are
near to the appliance.
2) Always position pans over the centreof
the cook zone, and turn the handles
to a safe position so they cannot be
accidentally knocked or grabbed.
3) Don't leave pans on the hob when
you're not around - take them off the cook
zone if you have to leave the kitchen even
if you think it will only be for a moment,
while you answer the door or phone.
4) If you use a griddle plate ensure it is
completely cool before attempting to lift it
from the hob as residual heat may cause
burns, Always use oven gloves to protect
your hands.
5) The appliance has a glass hob top,
make sure you do not drag pans across
the ceramic surface as this will lead to
scratches and damage.
6) Do not use the hob surface as a
chopping board or food preparation area
as this may lead to it becoming damaged.
7) Warning:- Do not use the hob if the
glass is cracked, as electrical parts are
directly beneath. To avoid the possibility of
electric shock, turn off the electricity supply
to the hob at the socket and arrange a
service call.
8) The glass ceramic can get hot whilst
cooking; even though the cook zone
itself does not generate heat. The heat
generated is conducted back from the hot
pans.
9) Keep electrical leads from trailing over
or going near the hob.
10) Warning:- Metallic objects such as
knives, forks, spoons and lids should not
be placed on the hob surface since they
can get hot.
safety
11) Warning:- Ensure you switch off the
appropriate cook zone individually or
by the central on/off key when you have
finished cooking, do not rely upon the
automatic pan detection system as your
means of switching "off" the appliance.
12) The appliance must never be
disconnected from the mains supply
during use as this will seriously affect the
safety and performance, particularly in
relation to surface temperatures becoming
hot and component parts not working
efficiently. The cooling fan (if fitted) is
designed to run on after the control has
been switched off.
13) This induction hob complies with the
applicable EMC and EMF standards.
Therefore it should not interfere with
other electronic units. Persons fitted with a
pacemaker or any other electrical implant
should clarify with their doctor or the
producer of the implant, whether there
implant is adequate and fail-safe, the
pacemaker must be designed in compliance
with the appropriate regulations.