Belling IH60 Users Manual & Installation Handbook page 16

InstallatIon InstructIons - InductIon
clearances and dimensions – requirements
No shelf or overhang of combustible
material should be closer than 650mm
above the hob.
There must be a minimum clearance of
50mm between the edges of the hob
and any side walls; this clearance must
be maintained up to 420mm above the
worktop.
Clearances and dimensions – requirements
There must be a minimum clearance of
50mm between the rear edge of the hob
No shelf or overhang of combustible material should be closer than 650mm above the hob.
and the rear wall. This clearance must
There must be a minimum clearance of 50mm between the edges of the hob and any side
be maintained up to 650mm above the
walls; this clearance must be maintained up to 420mmabove the worktop.
worktop.
There must be a minimum clearance of 50mm between the rear edge of the hob and the rear
When installing an extractor hood above
wall. This clearance must be maintained up to 650mm above the worktop.
the hob, refer to their Manufacturer's
instructions.
When installing an extractor hood above the hob, refer to their Manufacturer's instructions.