Belling IH60 Users Manual & Installation Handbook page 19

InstallatIon InstructIons - InductIon
connect to the electricity supply
Warning: This appliance must be earthed.
The hob must be installed by a competent
electrician, using a suitable double pole
control unit, with 3mm minimum contact
separation at all poles.
We recommend that the appliance is
connected by a competent person who is a
member of a "Competent Person Scheme"
who will comply with the required local
regulations.
Connection should be made with a
suitable cable. Important: Ensure that you
route all mains electrical cables well away
from any adjacent heat source, such as an
oven or grill.
Strip the wires & connect to the terminal
block as shown in the diagram & table
below.
Fit the cable clamp & secure with the screw
provided.
Close the terminal box, ensuring that the
cover is engaged on the locking tabs.