Belling IH60 Users Manual & Installation Handbook page 17

InstallatIon InstructIons - InductIon
Fitting into worktop
Cut a hole in the work surface to the
required size.
A clearance of at least 50mm should be
maintained between the cutout and any
rear or side wall.
The worktop must be of heat-resistant
material or covered with heat-resistant
material.
Protecting the cut-out;
The types of chipboard used for work
surfaces swell relatively quickly in contact
with humidity.
Apply a special varnish or adhesive to
the cut edge to protect it from steam or
condensation which may form under the
work surface under the hob.
This hob can be installed conventionally
(glass above the work top) or recessed into
the work top for a flush fit.
conventional Installation
Apply the self adhesive seal to the
underside edges of the hob glass. For best
results, the seal should be adhered along
each side in turn, as close to the edge as
possible, and trimmed at each corner,
taking care to ensure a neat join.
Place the hob in the aperture, checking the
hob glass is covering the work top along
all four sides.
Set the front edge of the appliance parallel
with the front of the work top.
Locate and attach the securing clamps
as required, Tighten the screws so that
the hob is pulled down firmly against the
worktop, thus ensuring a good seal.
Place the hob in the aperture, checking the hob glass is covering the work to
four sides.
Set the front edge of the appliance parallel with the front of the work top.
Locate and attach the securing clamps as required, Tighten the screws so th
down firmly against the worktop, thus ensuring a good seal.
recessed Method (selected models)
Recess the work top to the appropriate
depth (Approx 5mm) and shape to fit the
hob (add 1mm to overall glass size.
Apply the self adhesive seal to the
underside of the hob glass. For best
results, the seal should be adhered along
each joint in turn, as close to the edge
as possible, and trimmed at each corner,
taking care to ensure a neat join. Insert
the hob into the recess, ensuring that the
foam seal is sitting correctly.
Installation Instructions
Locate and attach the securing clamps to
Recessed Method (selected models)
the front and rear underside of the hob,
using the screws provided. Tighten the
Recess the work top to the appropriate depth (Approx 5mm) and shape to fit the hob (add 1mm
to overall glass size.
screws so that the hob is pulled down
Apply the self adhesive seal to the underside of the hob glass. For best results, the seal should
firmly against the worktop, thus ensuring a
be adhered along each joint in turn, as close to the edge as possible, and trimmed at each
corner, taking care to ensure a neat join. Insert the hob into the recess, ensuring that the foam
good seal.
seal is sitting correctly.
Locate and attach the securing clamps to the front and rear underside of the hob, using the
You may want to fill any gap between the
screws provided. Tighten the screws so that the hob is pulled down firmly against the worktop,
hob top glass and the work top surface
thus ensuring a good seal.
with silicone sealant. DO NOT fit silicone
You may want to fill any gap between the hob top glass and the work top surface with silicone
sealant. DO NOT fit silicone sealant under the glass hob instead of foam seal
sealant under the glass hob instead of
foam seal.
.