Cleaning The Water Filter / Draining The Residual Water - Whirlpool WWDE 7512 Instructions For Use Manual

CLEANING THE WATER FILTER /
DRAINING THE RESIDUAL WATER
WARNING
Make sure that the washer dryer has been shut
off and disconnected from its electrical power
supply before cleaning the water filter or draining
the residual water .If a high temperature wash
1 .
Remove the kick panel: Using a screwdriver,
do that which is shown in the following figure .
2 .
Container for the drained water:
Place a low and wide container under the water
filter in order to collect the residual water .
26
programme has recently been used, wait for the
water to cool before draining it .
The water filter should be cleaned regularly in
order to prevent water from remaining inside
the appliance after wash cycles due to filter
obstructions .
3 .
Drain the water:
Slowly turn the filter counter-clockwise until all the
water has come out .Allow the water to flow out
without removing the filter .
Once the container is full, close the water filter by
turning it clockwise . Empty the container . Repeat
the procedure until all the water has been drained .
4 .
Remove the filter: Place a cotton cloth under
the water filter in order to absorb any small
amounts of residual water . Next, remove the water
filter by turning it counter-clockwise .