Cleaning The Water Filter / Draining The Residual Water - Whirlpool FreshCare WFWDC96 User Manual

CLEANING THE WATER FILTER /
DRAINING THE RESIDUAL WATER
WARNING
Make sure that the washer dryer has been shut off and
disconnected from its electrical power supply before cleaning the
water filter or draining the residual water.If a high temperature
wash programme has recently been used, wait for the water to
cool before draining it.
1.
Remove the kick panel: Using a screwdriver, do that which is
shown in the following figure.
2.
Container for the drained water:
Place a low and wide container under the water filter in order to
collect the residual water.
The water filter should be cleaned regularly in order to prevent
water from remaining inside the appliance after wash cycles due to
filter obstructions.
3.
Drain the water:
Slowly turn the filter counter-clockwise until all the water has come
out.Allow the water to flow out without removing the filter.
Once the container is full, close the water filter by turning it
clockwise. Empty the container. Repeat the procedure until all the
water has been drained.
4.
Remove the filter: Place a cotton cloth under the water filter
in order to absorb any small amounts of residual water. Next,
remove the water filter by turning it counter-clockwise.
EN
15