Other Operating Instructions; Cleaning The Lint Filter - Whirlpool Thin Twin LT4905XM Use & Care Manual

Other operating instructions
For a rinse and spin
I
.-
22bfr
D"Sh stop
For a drain and spin
You may need an extra rinse and Your washer can be set to drain
spin for heavily soiled loads which
and spin out water.
need more detergent. (Extra de-
l
Push Control Knob in.
tergent can require an extra rinse.)
0 Turn ClOCkwIse to the bar lust before
l
Push Control Knob in.
OFF. See above drawing.
l
Turn clockwise to any.on the dial.
l
Pull Control Knob out.
See above drawing.
l
The washer will drain and spin.
l
Pull Control Knob out.
l
The washer will fill to selected level
with cold water, agitate 2 minutes,
drain and spin.
For agitation and spin speeds in each cycle, see pages 8 and 9.
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing soiled
laundrv.
l
Use enough detergent or pre-soak
product for a single load.
l
Push Control Knob in.
Turn clockwise to point at a number
in the SOAK CYcle.
Pull Control Knob out.
When the cycle is over, add de-
tergent for the next selected wash
cycle. Important: See additional
care intormation on page 7 of your
"Laundry Guide!'
Set the washer and start the next
selected wash cycle.
To start the soak or pre-wash with agitation, the Cycle Control
Knob must point to a number in the SOAK Cycle.
Cleaning the lint filter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it's clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter.
10