HOW TO USE THE WASHER DRYER
1 . LOADING LAUNDRY .
• Prepare the laundry, following the
recommendations given in the section
"HINTS AND TIPS" . - Open the door and
load the laundry into the drum, without
exceeding the maximum load capacities
indicated in the Programmes and Options .
• Close the door, pressing until the latch audibly
locks, and check that there is no
laundry trapped between the door
glass and the rubber seal .
2 . OPEN THE WATER TAP
Check that the washer dryer is
connected correctly to the water mains .
Open the water tap .
3 . SWITCHING ON THE WASHER DRYER
; the lamp
4 . SELECTING A PROGRAMME AND
CUSTOMISING A CYCLE .The following functions
are possible with this appliance:
• Wash only
• Wash and dry
• Dry only
Select the required programme with the
PROGRAMME selector dial . The washer-
dryer automatically displays the maximum
temperature specified for the programme set, via
the corresponding led light . Press the relevant
button to change the temperature .
• Pressing the
«Temp . °C»
temperature progressively, to a minimum of
20 °C . Pressing the button again will return to
the maximum temperature permitted for the
Select the required options (if necessary) .
• Press the button to select the option; the
respective button lamp illuminates .
• Press the button again to cancel the option; the
lamp extinguishes .
! If the selected option is not compatible with the
programme set, an error warning tone sounds
and the indicator lamp flashes three times . The
option is not selected .
Wash and dry
To wash and dry a load with no interruption
between the wash and dry cycles, make sure
that the load does not exceed the maximum
permissible drying load for the selected
programme (see the column "Max. drying load" in
the Programmes and Options) .
Follow the instructions given in the
paragraph "Wash Only" to select and, if
necessary, customise the required programme .
flashes slowly .
button reduces the
Select the type of drying desired, by
pressing the "Dryness level" button for
automatic drying levels or the «Drying
button to set drying time .
- Automatic drying with selectable levels:
In automatic drying mode, the washer dryer
machine dries the laundry until the set
level of dryness is reached . Pressing button
"Dryness level" once automatically selects the
highest drying level available for the selected
programme . Press the button again to reduce
the drying level .
The following levels are available:
: laundry is completely dry and
ready to be put away in the wardrobe without
: laundry is left slightly damp to
minimise creasing . Garments must be hung to
air dry completely .
: garments are left reasonably damp to
make ironing easier .
- Timer drying mode:
To set a specific drying time, press the «Drying
time» button until the led for the desired time
is illuminated . Values from 180 to 40 minutes
To wash a load of laundry larger than the
maximum permissible load for drying (see the
column "Max. drying load" in the Programmes
and Options), remove a few garments once the
washing cycle has finished before starting the
drying cycle . Proceed as follows:
1 . Follow the instructions given in the paragraph
"Wash Only" to select and, if necessary,
customise the required programme .
2 . Do not include a drying cycle .
3 . Once the washing cycle is finished, open the
door and remove a few garments to reduce
the load . Now follow the instructions for "Dry
N .B .: always allow a cooling down period after
drying before opening the door .
When using the two preset cycles "Wash & Dry
45'" and "Wash & Dry 90'", it is not necessary to
select and start a drying cycle .
This function is used to simply dry a wet load
washed previously in the washer dryer or by
1 . Select a suitable programme for the laundry
you want to dry (e . g . select cotton to dry wet
cotton laundry) .