Other Operating Instructions; Cleaning The Lint Filter - Whirlpool thin twin LT5000XM Use & Care Manual

Other operating instructions
lo
regular permanent
heavy heavy
permanent
For a rinse and spin For a drain and spin
"You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.)
• Push Control Knob in.
• Turn clockwise to anyeon the dial.
See above drawing.
= Pull Control Knob out.
• The washer will fill to selected
level: agitate 2 minutes: drain
and spin.
For agitation and spin speeds in
For a soak or ple-wash
For best results, use warm water
for soaking or pre-washing stained
laundry. Hot water can set stains.
22
Your washer can be set to drain
and spin out water.
• Push Control Knob in.
• Turn clockwise to the bar lust before
OFF. See above drawing.
• PullControl Knob out.
* The washer willdrain and spin.
each cycle,see pages 8 and 9.
• Use recommended amount of
detergent or pre-soak product.
• Push Control Knob in.
* Turn clockwise to point at a number
in the SOAK Cycle.*
e Pull Control Knob out to start washer.
e When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
"Laundry Guide:'
*To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint f'dter
fO
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it's clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter.