Cisco Codec C20 Reference Manual page 52

Cisco TelePresence System Codec C20
Contents Introduction
xConfiguration SIP Profile [1..1] Authentication [1..1] Password
This is the password part of the credentials used to authenticate towards the SIP proxy.
Requires user role: ADMIN
Value space: <S: 0, 128>
Format: String with a maximum of 128 characters.
example: xConfiguration SIP Profile 1 Authentication 1 Password: ""
xConfiguration SIP Profile [1..1] DefaultTransport
Select the transport protocol to be used over the LAN.
Requires user role: ADMIN
Value space: <TCP/UDP/Tls/Auto>
TCP: The system will always use TCP as the default transport method.
UDP: The system will always use UDP as the default transport method.
Tls: The system will always use TLS as the default transport method. For TLS connections a SIP
CA-list can be uploaded to the video system. If no such CA-list is available on the system then
anonymous Diffie Hellman will be used.
Auto: The system will try to connect using transport protocols in the following order: TLS, TCP, UDP.
example: xConfiguration SIP Profile 1 DefaultTransport: Auto
xConfiguration SIP Profile [1..1] TlsVerify
For TLS connections a SIP CA-list can be uploaded to the video system.
Requires user role: ADMIN
Value space: <Off/On>
Off: Set to Off to allow TLS connections without verifying them. The TLS connections are allowed to
be set up without verifying the x.509 certificate received from the server against the local CA-list.
This should typically be selected if no SIP CA-list has been uploaded.
On: Set to On to verify TLS connections. Only TLS connections to servers, whose x.509 certificate
is validated against the CA-list, will be allowed.
example: xConfiguration SIP Profile 1 TlsVerify: Off
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration xConfiguration
xConfiguration SIP Profile [1..1] Outbound
xConfiguration SIP Profile [1..1] Proxy [1..4] Address
xConfiguration SIP Profile [1..1] Proxy [1..4] Discovery
52
xCommand
The client initiated connections mechanism for firewall traversal, connection reuse and redundancy. The
current version supports http://tools.ietf.org/html/draft-ietf-sip-outbound-20.
Requires user role: ADMIN
Value space: <Off/On>
Off: Connect to the single proxy configured first in Proxy Address list.
On: Set up multiple outbound connections to servers in the Proxy Address list.
example: xConfiguration SIP Profile 1 Outbound: Off
The Proxy Address is the manually configured address for the outbound proxy. It is possible to use a
fully qualified domain name, or an IP address. The default port is 5060 for TCP and UDP but another
one can be provided. If Outbound is enabled, multiple proxies can be addressed.
Requires user role: ADMIN
Value space: <S: 0, 255>
Format: Compact string with a maximum of 255 characters. An IP address that contains letters
(192.a.2.0) or unvalid IP addresses (192.0.1234.0) will be rejected.
example: xConfiguration SIP Profile 1 Proxy 1 Address: ""
Select if the SIP Proxy address is to be obtained manually or by using Dynamic Host Configuration
Protocol (DHCP).
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: When Auto is selected, the SIP Proxy address is obtained using Dynamic Host Configuration
Protocol (DHCP).
Manual: When Manual is selected, the manually configured SIP Proxy address will be used.
example: xConfiguration SIP Profile 1 Proxy 1 Discovery: Manual
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.