Cisco Codec C20 Reference Manual page 46

Cisco TelePresence System Codec C20
Contents Introduction
xConfiguration NetworkServices SNMP Mode
SNMP (Simple Network Management Protocol) is used in network management systems to monitor
network-attached devices (routers, servers, switches, projectors, etc) for conditions that warrant admin-
istrative attention. SNMP exposes management data in the form of variables on the managed systems,
which describe the system configuration. These variables can then be queried (set to ReadOnly) and
sometimes set (set to ReadWrite) by managing applications.
Requires user role: ADMIN
Value space: <Off/ReadOnly/ReadWrite>
Off: Disable the SNMP network service.
ReadOnly: Enable the SNMP network service for queries only.
ReadWrite: Enable the SNMP network service for both queries and commands.
example: xConfiguration NetworkServices SNMP Mode: ReadWrite
xConfiguration NetworkServices SNMP Host [1..3] Address
Enter the address of up to three SNMP Managers.
The system's SNMP Agent (in the codec) responds to requests from SNMP Managers (a PC program
etc.), for example about system location and system contact. SNMP traps are not supported.
Requires user role: ADMIN
Value space: <S: 0, 64>
Format: String with a maximum of 64 characters.
example: xConfiguration NetworkServices SNMP Host 1 Address: ""
xConfiguration NetworkServices SNMP CommunityName
Enter the name of the Network Services SNMP Community. SNMP Community names are used to
authenticate SNMP requests. SNMP requests must have a password (case sensitive) in order to receive
a response from the SNMP Agent in the codec. The default password is "public". If you have the Cisco
TelePresence Management Suite (TMS) you must make sure the same SNMP Community is configured
there too. NOTE: The SNMP Community password is case sensitive.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
example: xConfiguration NetworkServices SNMP CommunityName: "public"
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration xConfiguration
xConfiguration NetworkServices SNMP SystemContact
xConfiguration NetworkServices SNMP SystemLocation
xConfiguration NetworkServices SSH Mode
xConfiguration NetworkServices SSH AllowPublicKey
46
xCommand
Enter the name of the Network Services SNMP System Contact.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
example: xConfiguration NetworkServices SNMP SystemContact: ""
Enter the name of the Network Services SNMP System Location.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
example: xConfiguration NetworkServices SNMP SystemLocation: ""
SSH (or Secure Shell) protocol can provide secure encrypted communication between the codec and
your local computer.
Requires user role: ADMIN
Value space: <Off/On>
Off: The SSH protocol is disabled.
On: The SSH protocol is enabled.
example: xConfiguration NetworkServices SSH Mode: On
Secure Shell (SSH) public key authentication can be used to access the codec.
Requires user role: ADMIN
Value space: <Off/On>
Off: The SSH public key is not allowed.
On: The SSH public key is allowed.
example: xConfiguration NetworkServices SSH AllowPublicKey: On
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.