Cisco Codec C20 Reference Manual page 43

Cisco TelePresence System Codec C20
Contents Introduction
xConfiguration Network [1..1] MTU
Set the Ethernet MTU (Maximum Transmission Unit).
Requires user role: ADMIN
Value space: <576..1500>
Range: Select a value from 576 to 1500 bytes.
example: xConfiguration Network 1 MTU: 1500
xConfiguration Network [1..1] Speed
Set the Ethernet link speed.
NOTE: If running older software versions than TC6.0, restart the system for any change to this setting
to take effect.
Requires user role: ADMIN
Value space: <Auto/10half/10full/100half/100full/1000full>
Auto: Autonegotiate link speed.
10half: Force link to 10 Mbps half-duplex.
10full: Force link to 10 Mbps full-duplex.
100half: Force link to 100 Mbps half-duplex.
100full: Force link to 100 Mbps full-duplex.
1000full: Force link to 1 Gbps full-duplex.
example: xConfiguration Network 1 Speed: Auto
xConfiguration Network [1..1] TrafficControl Mode
Set the network traffic control mode to decide how to control the video packets transmission speed.
Requires user role: ADMIN
Value space: <Off/On>
Off: Transmit video packets at link speed.
On: Transmit video packets at maximum 20 Mbps. Can be used to smooth out bursts in the outgo-
ing network traffic.
example: xConfiguration Network 1 TrafficControl: On
xConfiguration Network [1..1] RemoteAccess Allow
Filter IP addresses for access to ssh/telnet/HTTP/HTTPS.
Requires user role: ADMIN
Value space: <S: 0, 255>
Format: String with a maximum of 255 characters, comma separated IP adresses or IP range.
example: xConfiguration Network 1 RemoteAccess Allow: "192.168.1.231, 192.168.1.182"
Codec C20 API Reference Guide TC6.0 February 2013.
D14869.05
About the API xConfiguration xConfiguration
xConfiguration Network [1..1] VLAN Voice Mode
xConfiguration Network [1..1] VLAN Voice VlanId
43
xCommand
Set the VLAN voice mode. The VLAN Voice Mode will be set to Auto automatically if you choose Cisco
UCM (Cisco Unified Communications Manager) as provisioning infrastructure via the Provisioning Wizard
on the Touch controller.
Requires user role: ADMIN
Value space: <Auto/Manual/Off>
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If CDP is
not available, VLAN is not enabled.
Manual: The VLAN ID is set manually using the Network VLAN Voice VlanId setting. If CDP is avail-
able, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.
example: xConfiguration Network 1 VLAN Voice Mode: Off
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
Requires user role: ADMIN
Value space: <1..4094>
Range: Select a value from 1 to 4094.
example: xConfiguration Network 1 VLAN Voice VlanId: 1
API Reference Guide
xStatus Appendices
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.