Installing Crop Dividers Without Latch Option - MacDon D65 Assembly Instruction Manual

3.6 Installing Crop Dividers without Latch Option

NOTE:
If crop divider latch option was ordered with header, proceed to
27. Otherwise, complete the following procedure:
1. If not already open, open endshields. Refer to
Opening Endshield, page
2. Position crop divider as shown by inserting lugs (A) into
holes (B) in endsheet.
3. Lift forward end of crop divider and install bolt (B) and
special stepped washer (A) (step towards divider).
Tighten bolt.
4. Check that divider does not move laterally. Adjust
bolts (A) as required to tighten divider and remove
lateral play when pulling at divider tip.
5. Close endshield. Refer to
29.
214328
ASSEMBLING HEADER
3.3
25.
3.7 Closing Endshield, page
3.5 Installing Crop Dividers with Latch Option, page
Figure 3.23: Crop Divider Installation
Figure 3.24: Crop Divider Installation
Figure 3.25: Crop Divider Adjustment
28
Revision A