Lowering Double-Reel Header - MacDon D65 Assembly Instruction Manual

5. Place 150 mm (6 in.) blocks (A) under each end and
center of cutterbar. Lower header onto blocks.
6. Remove chain and move lifting vehicle to rear
of header.
7. Attach chain to center-link anchor on frame tube and
raise rear of header so that stand can be lowered.
8. Lower header stand: pull pin (A), lower stand (B), and
releasing pin (A) to secure stand in place.
9. Lower header onto stand.
NOTE:
If ground is soft, place a block under the stand.
10. Remove chain.

2.2.2 Lowering Double-Reel Header

Reposition header in preparation for assembly and setup as follows:
1. Choose an area with level ground.
2. Drive lifting vehicle to approach header from
its underside.
214328
UNLOADING HEADER
Figure 2.6: Blocks at Each End and Center
of Cutterbar
Figure 2.7: Header Stand
Figure 2.8: Header on Shipping Stands
9
Revision A