Seat alhambra Owner's Manual page 87

W W A A R R N N I I N N G G
T T o o e e n n s s u u r r e e t t h h a a t t n n o o b b o o d d y y i i s s i i n n j j u u r r e e d d w w h h e e n n c c l l o o s s i i n n g g t t h h e e w w i i n n d d o o w w s s o o r r
s s l l i i d d i i n n g g / / t t i i l l t t i i n n g g r r o o o o f f , , t t h h e e o o p p e e r r a a t t o o r r s s h h o o u u l l d d a a l l w w a a y y s s w w a a t t c c h h t t h h e e w w i i n n d d o o w w s s a a n n d d
s s l l i i d d i i n n g g / / t t i i l l t t i i n n g g r r o o o o f f a a s s t t h h e e y y c c l l o o s s e e . .
C C a a r r e e l l e e s s s s o o r r u u n n c c o o n n t t r r o o l l l l e e d d c c l l o o s s i i n n g g o o f f t t h h e e w w i i n n d d o o w w s s c c a a n n c c a a u u s s e e i i n n j j u u r r i i e e s s . .
Individual opening of the doors
O O p p e e n n i i n n g g w w i i t t h h t t h h e e i i n n d d i i v v i i d d u u a a l l o o p p e e n n i i n n g g a a c c t t i i v v a a t t e e d d
To o o p p e e n n the car, point the key at it within the effective range and
briefly press the opening button
Only the driver's door is unlocked. The safety lock and the anti-
theft alarm* are immediately deactivated, and all the indicators
flash to show this.
• If you press the opening button
locks are unlocked.
• The safety lock and the anti-theft alarm* remain deactivated.
N N o o t t e e
All other individual door opening functions can be found in the "Doors,
K
central locking" chapter.
Safety First
K
fig. 68, arrow o o n n c c e e :
⇒
1
fig. 68, arrow t t w w i i c c e e all the
⇒
1
Controls and equipment
Synchronisation
If the vehicle cannot be opened by pressing the radio transmitter
button, it could be that the code of the key no longer matches that
of the control unit in the vehicle. This can occur if the transmitter
button is frequently pressed outside the effective range of the
system.
The infrared key must be resynchronized. The synchronization
process must be completed with 1 1 m m i i n n u u t t e e .
The necessary steps for the programming of the key are:
1. Insert key into driver's door lock and turn three times forwards
(unlock), before 5 seconds have elapsed (maximum). Each time
hold it for 1/2 second in the unlock position. Remove key. The
warning lamp in the inner driver's door cover will flash to show that
the operation has been properly completed.
2. Press and hold "close" button
3. Press "open" button fig.
⇒
"close" button. The key has now been recoded. To check the
system, the warning lamp in the door trim will flash, and the light
in the key will flash 5 times.
If any further infrared keys are being used, they must also be
synchronised. To do this, steps 2 to 4 of the synchronisation
procedure must be carried out. This procedure must not last any
longer than 15 seconds for each key and must be carried out
immediately after the synchronisation of the previous key.
Tips and Maintenance
Opening and closing
fig. 68, arrow .
⇒
2
68, arrow 3 times. Release
1
Technical Data
83