Seat alhambra Owner's Manual page 226

222 If and when
Reading light
Fig. 190
B7M-0019
AL0-145
Fig. 191
• Remove complete light carrier (inner and reading light), to do this
insert the flat blade of screwdriver (it is in the long end of the
wheel spanner "Vehicle tools", page 202) between light and
⇒
headlining and turn screwdriver.
• Turn bulb holder on back of light in direction of arrow and remove
fig. 191.
⇒
• Pull defective glass based bulb out of holder.
• Insert new bulb.
• Insert holder in housing again and turn fully to right.
• First insert left side of light carrier and then press into the
K
opening in headlining.
I I n n s s t t a a l l l l i i n n g g a a r r a a d d i i o o
When retro-fitting a radio, but also when replacing a set installed
by the factory the following points should be noted:
• The connection* in the vehicle is for Genuine SEAT radios
• Radios with other connections must be connected with an
adapter cable which can also be obtained from Technical Service
Centres.
1) Not available in all countries
1) .