Mileage Clock With Service Interval Indicator; B Trip Mileage Clock/Reset Service Interval Indicator - Seat alhambra Owner's Manual

52 Instrument panel
Mileage clock/Trip mileage
The upper counter registers the total distance driven and the lower
one the short trips.
The last figure of the lower counter indicates 100 m.
The trip mileage can be put back to zero by pressing the reset knob
fig. 46 next to the speedometer.
⇒
B
Service interval indicator*
If a service is due, the word "Service" will flash for about 20
seconds when the engine is switched on, the vehicle is not moving
and the mileage clock reset button is not touched.
The deadline for any service will be displayed 3,000 km in
advance.
• • I I n n t t e e r r m m i i t t t t e e n n t t s s e e r r v v i i c c e e * * f f o o r r 2 2 0 0 s s e e c c o o n n d d s s . Indicates that the time for a
new service has elapsed.
• • S S e e r r v v i i c c e e K K m m 3 3 , , 0 0 0 0 0 0 * * f f o o r r 2 2 0 0 s s e e c c o o n n d d s s . Indicates that the next service
is due in 3,000 km. Every 100 km the number of km will decrease
by 100 km up to the indication "Service".
A A f f t t e e r r t t h h e e s s e e r r v v i i c c e e h h a a s s b b e e e e n n p p e e r r f f o o r r m m e e d d t t h h e e d d i i s s p p l l a a y y n n e e e e d d s s t t o o b b e e
r r e e s s e e t t . .
The display will be reset by a Technical Service Centre as follows:
• With the ignition switched off, press and hold the trip meter reset
button below the speedometer.
K
• Switch ignition on and release the reset button. The display will
show the next service.
• Turn the minute button of the digital clock to the right.
• Switch ignition off. Now the service indicator has been set to
zero.
T T h h e e s s e e r r v v i i c c e e i i n n d d i i c c a a t t o o r r c c a a n n n n o o t t b b e e c c o o m m p p l l e e t t e e l l y y s s e e t t t t o o z z e e r r o o . . I I t t c c a a n n o o n n l l y y
b b e e s s e e t t t t o o 1 1 5 5 , , 0 0 0 0 0 0 k k m m . .
N N o o t t e e
• Do not zero the display between the Service intervals. Otherwise an
incorrect reading will be shown.
• If the battery is disconnected the details in the service display are
retained.
• If the instrument panel changes due to repair, the service interval display
must be reset. This should be carried out by a Technical Service Centre.
Should the display not be reprogrammed, then the service work should be
carried out in accordance with the Inspection and Maintenance Plan and not
according to the Service Interval Display. The Service interval indicator only
becomes valid again after carrying out an inspection and resetting the
indicator.
F F a a u u l l t t i i n n d d i i c c a a t t o o r r
If a failure occurs, "FAIL" would appear either on the instrument
panel or the trip meter. The defect should be repaired by a
Technical Service Centre as soon as possible.
K