Table of Contents
Advertisement
FS-lT4S
Digital proportional radio control system
9 i-Bus Setup
After connecting the i-Bus module to your receiver and servos, select steering, throttle, channel 3 or 4.
The system will display a prompt saying "Press the corresponding servo interface button or touch cancel.".
Locate the desired servo, and using the tool provided to push the channels button on the i-Bus module.
9.1 Servos frequency
Some types of servo will require a different frequency to function properly, to change this value simply
use the wheel to change it. Consult your servos user manual to find out the correct frequency.
Note
The most common frequency is 50Hz.
9.2 Range Test
The range test function is useful for finding out if there are sources of interference nearby.
To preform a range test pair the RX and TX, then open this function. Press SW2 (Located near your small
finger on the grip of the transmitter) and walk slowly away from your model.
30
Advertisement
Table of Contents
