Steering Exponential - Fly Sky FS-lT4S Instruction Manual

The method for changing settings in this function is the wheel located above the menu bar at the bottom.
To restore default settings of a single channel, select the reset icon within its subtrim menu.
□
To restore the entire function to default, select the reset icon in the channel selection menu.
□
Channel List

6.2 Steering Exponential

This function changes the response curve of the steering, there are 2 main parameters:
□ Rate: Changes the outer limits of the steering, the default is 100%. Rate cannot be more than 100%.
□ Exp.: Changes the steering curve, which changes he response of the steering wheel, the exp setting
can be positive or negative. (Exponential)
Changes to the rate and exponential can be seen on the graph located
in the center of the screen, the system also gives a real-time readout of
the channels current position.
Changes to the rate and exponential can be seen on the graph, located
in the center of the screen. The system also gives a real-time readout of
the channels current position.
Note:
The system gives a real time readout of the channels position, not the
wheels position. The wheel will not correlate with the graph if the rate
is under 100% ,or another function like trim has made changes to the
channels movement and/or outer.
By changing the steering curve we can make the wheel more or less
sensitive in at different areas of its range of movement, for example,
reducing sensitivity at the middle for more control when making fine
adjustments.
This function must be set as active before use, to activate the function
make sure that the icon in the bottom left corner is showing a tick, if
there is no tick then press the icon to enable.
Subtrim setting and channel's current position
Exponential 100%
15