Display; Rotokeys - Furuno NavNet 3D MFDBB Operator's Manual

Chapter 1: Operational Overview

ROTOkeys

The ROTOkeys are like "soft keys"; they change according to active display. The RO-
TOkeys are hidden until you elect to display them. To display the ROTOkeys, simply
rotate or push the Rotary Knob, and they appear at the right edge of the screen. By
long-pushing the Rotary Knob you can display a greater quantity of ROTOkeys. In the
default set up a short push shows the "basic" set and a long push shows the "stan-
dard" set. A "full" set and "custom" set are also available.
The ROTOkeys are auto-hiding, and are erased from the screen if not operated within
about six seconds. They can also be manually hid by using the CANCEL key.
There are three categories of ROTOkeys: Single level, multi-level and specialty

display.

To select a ROTOkey for adjustment do the following:
1. Rotate or push the Rotary Knob to show the ROTOkeys. (Long-push the knob to
show the "standard" keys. These keys can also be activated when the "basic"
keys are shown.) In the example below, a few of the basic ROTOkeys for the chart
plotter are shown.
Active ROTOKey (magnified and blue)
ROTOKey category identifier
2. Rotate the Rotary Knob to select the ROTOkey you wish to use.
As you step through the ROTOkey selections, the active ROTOkey is magnified
and blue and inactive ones are grey.
3. Do one of the following depending on category of ROTOkey.
Single level: Push the Rotary Knob to color the status indicator (left of the
ROTOkey label) green to turn on the respective item, or gray to turn it off.
Multi-level: Push the Rotary Knob, rotate it to select desired ROTOkey and push
it to confirm selection.
Specialty display: Push the Rotary Knob to show the display whose name
appears on the ROTOkey label.
1-10
: Single level
ON: Green
OFF: Gray
: Multi-level
No box: Specialty display
Basic ROTOkeys for chart plotter
Inactive ROTOKey (gray