ER-SF1 Event Recorder with J1939 Network Instructions for Self Installation
Optional Tools
The following tools are not required for installation but can be helpful:
Cordless driver
Add-a-circuits or vehicle specific
connectors
Grommets and looms
Flashlight
INSTALLATION PROCEDURES
Installation consists of three sections:
1. Mounting of the bracket and event recorder in the vehicle
2. Electrical connections and cable routing
3. Testing
Mount the Bracket and Event Recorder
CAUTION:
To mount the bracket and ER, the air temperature must be at least 50F (10C).
WARNING:
Before mounting the bracket and ER, consult the vehicle manufacturer's
recommendations and any applicable federal, state, provincial and local laws that prohibit
mounting devices on vehicle's windshield or other locations in a vehicle.
Mounting the bracket and ER consists of five main steps:
1. Review mounting location guidelines.
2. Clean and dry the windshield.
3. Mark the mounting location on the windshield.
4. Attach the bracket to the windshield.
5. Mount the ER to the bracket.
© 2017 Lytx, Inc. – Confidential & Proprietary – For Velociti's Use Only Re Beta ER-SF1 Installations. Page 11 of 26
Paper towels/shop towel
Utility knife
Vehicle-specific panel clips
Spare 18-gauge wire