Table of Contents
Advertisement
ER-SF1 Event Recorder with J1939 Network Instructions for Self Installation
Mark the Mounting Location on the Glass
CAUTION:
Do not peel the backing from the adhesive strips on the bracket in this section.
1. Following the mounting location guidelines above, hold the assembly in place and trace the
outline of the bracket on the windshield with a marker. Make sure the traced guide marks are
level.
2. Remove the event recorder from the mounting bracket.
3. Check the fit of the bracket against the windshield. If the windshield is curved, you may
gently bend the bracket so it will lie flush against the glass.
4. Check again to make sure you've selected the best mounting location.
a. Sit in the driver's seat while holding the ER device up. Make sure it doesn't block the
driver's view of the road.
b. Turn on the wipers and rotate mirrors, sun visors, and other objects near the ER to
make sure they cannot block either lens.
Attach the Bracket to the Windshield
CAUTION:
The adhesive is very sticky. Once applied, it will not easily come off.
CAUTION:
Do not apply excessive pressure as it may cause the windshield to break.
1. Remove the backing from the adhesive side
of the bracket.
2. Carefully attach the bracket to the
windshield.
a. Place the top edge of the bracket
against the windshield, aligned with
the marks, and make sure it is level.
b. Press the bracket firmly against the
windshield starting at the top and
pressing the sides downward. See
Figures A and B.
3. Check from outside the vehicle for large air
bubbles under the bracket. If you find any:
a. Apply additional pressure to the
bracket.
b. Use a small pin to create an escape path for the air.
© 2017 Lytx, Inc. – Confidential & Proprietary – For Velociti's Use Only Re Beta ER-SF1 Installations. Page 14 of 26
Hide quick links:
Advertisement
Table of Contents
