Clean And Dry The Windshield - Lytx ER-SF1 Installation Instructions Manual

ER-SF1 Event Recorder with J1939 Network Instructions for Self Installation
*FMCSA Allowance: Allows the event recorder to be mounted not more than 100 mm (four inches)
below the upper edge of the area swept by the windshield wipers or not more than 175 mm (7
inches) above the lower edge of the area swept by the windshield wipers, provided that the event
recorder is located outside the driver's sight lines to the road and highway signs and signals. See
49 C.F.R. § 393.60(e).

Clean and Dry the Windshield

CAUTION: These steps—especially use of the alcohol wipe—are critical to prevent the bracket
from falling off later.
1. Clean the mounting area on the windshield thoroughly with the alcohol wipe, removing any
debris and moisture. This should be the area behind the rear view mirror on the passenger
side or the equivalent area if there is no rear view mirror (see below).
2. Dry the mounting area thoroughly with a clean, dry cloth.
© 2017 Lytx, Inc. – Confidential & Proprietary – For Velociti's Use Only Re Beta ER-SF1 Installations. Page 13 of 26
Thoroughly Clean and Dry the Glass