Marine Electronic Cathodic Anti-Corrosion System; Electrical Schematics - Sea Ray 250 Select EX Owner's Manual

S
13. M E
ARINE LECTRONIC
A -C
NTI ORROSION
The automatically controlled Cathodic Anti-Corrosion
System for marine installation protects underwater
metals from the effects of corrosion and electrolysis
on stern drives. The system components are
designed for marine service. DO NOT PAINT THE
®
MERCATHODE SYSTEM.
The anode and reference electrode are attached to
the electrode assembly under each stern drive unit.
The solid state controller is mounted within a plastic
housing on the transom in the bilge.
Maintenance
®
The Mercathode system must be tested to ensure
adequate output. The test should be performed
every 100 hours or annually. Contact your authorized
®
Sea Ray dealer to arrange for this test. Refer to
the engine operator's manual for more detailed
information.
6.10
6 • E
ECTION
C
ATHODIC
S
YSTEM
S
LECTRICAL
14. E
LECTRICAL
This owner's manual contains electrical schematics
and wiring harness illustrations for your boat. These
electrical schematics were generated by electrical
CAD designers at the engineering division for
technical reference and service technicians. Sea
Ray ® does not recommend that you attempt to work
on the boat's electrical system yourself. Instead,
we recommend that you take your boat to your
authorized Sea Ray
reserves the right to change or update the electrical
system on any model at any time without notice to
the consumer and is NOT obligated to make any
updates to units built prior to changes.
YSTEM
S
CHEMATICS
® dealer for service. Sea Ray
250 Select EX
®