Important Gauges; Smartcraft™ Gauge System; Tachometer; Oil Pressure, Water Temperature, Speedometer And Fuel Gauges - Sea Ray 250 Select EX Owner's Manual

S
ECTION
9. I G
MPORTANT AUGES
A. S C ™ G
MART RAFT AUGE
S C S T
MART RAFT YSTEM
(F . 2.10.1)
IG
Your boat is equipped with the SmartCraft
instrumentation system. The SmartCraft
consists of a smart tachometer with a display
screen.
TM
The SmartCraft system provides a wide range of
engine, boat systems and environmental information
to the boat operator to help make your time on the
water more enjoyable by providing accurate systems
information in one convenient location, right at the
helm. Below is a list of features the SmartCraft
system offers.
Refer to the SmartCraft
owner's packet for all SmartCraft
instructions.
S F I
OME EATURES NCLUDE
(Depending on en gine type and soft ware version)
S T D
YSTEM ACH ISPLAY
S :
CREEN
• Depth/Water Temperature
• Engine Alarm/Hourmeter
• Fuel Consumption/Usage
• Trim Level
• Troll Control
• Voltage
• Digital Speed
B. T
ACHOMETER
The tachometer indicates the revolutions per
minute (RPM) of the engine. (It does not indicate
2.10
2 • G
ENERAL
S
YSTEM
ACH
TM
system
TM
owner's manual in the
TM
operating
:
(F . 2.10.2)
IG
B A
OAT RRANGEMENT
the speed of the boat.) Your Engine Operator's
Manual indicates the maximum full throttle RPM at
which your engine should operate. This must not be
exceeded or serious engine damage will occur. The
tachometer should also be used to determine the
most comfortable and economical cruising RPM.
C. O P , W
IL RESSURE
S
PEEDOMETER AND
These gauges function on your boat the same way
they do on your car or truck. You must continually
check these gauges visually to make certain there
are no engine system problems even if your boat
engine has an alarm system.
TM
D. M C
AGNETIC OMPASS
M C
AGNETIC OMPASS
(F . 2.10.3)
IG
TM
Your compass, properly corrected, will indicate
magnetic north (not true north). A compass must
be adjusted by a qualified person. The reason
for this is that nearby instruments or objects
containing magnets or current-carrying electrical
wires will infl uence the compass reading. This is
especially true if you add electronic devices to the
helm station.
After your compass has been professionally
adjusted. You will be given a deviation card or
chart indicating the correction to be applied when
laying out a compass course or making navigational
calculations. Keep this correction card or chart
at the helm.
NOTE: The compass adjustment is only good for
the equipment arrangement that existed at the time
of the adjustment. If you place different equipment
or remove equipment from the vicinity of the
compass, you cannot rely on the compass reading.
The compass must be readjusted by a qualifi ed
T ,
ATER EMPERATURE
F G
UEL AUGES
250 Select EX