Dante Network Setup - Extron electronics AXI 22 AT D User Manual

Figure 20.
The major elements of the
•
•
•

Dante Network Setup

Use a standard Ethernet cable to connect the AXI to a network via the RJ-45 AT port (see
figure
Dante Controller auto-discovers all Dante devices on the network and advertises itself to
allow other Dante-enabled devices to communicate with it. The default device name is the
model number followed by the last six digits of the MAC address of the device. Multiple
devices on the same network can present difficulty in identifying inputs and outputs. To
avoid confusion, rename each device to a unique and meaningful identifier.
NOTE: To simplify renaming, connect only one Dante device to the network at a time. As
Dante Controller Network View Screen
Network View
Receivers, representing Dante device inputs, are on the left side listed vertically (see
figure 20, ).
1
Transmitters, representing Dante device outputs, are along the top listed horizontally
( ).
2
Connection points of the receivers and transmitters form a matrix in the lower-right
panel of the screen ( ).
3
3, , on page 5) and power the device. Launch the Dante Controller program.
D
each device is renamed, it can remain connected.
AXI 22 AT D • Dante Controller Configuration and Operation
screen include:
21