Extron electronics RWM 2 Installation Manual

RWM 2 • Installation Guide

Overview

The RWM 2 is an accessory kit allowing the TLP Pro 725M and TLP Pro 1025M touchpanels to be installed directly into drywall.
This guide provides instructions for experienced professional installers to mount and install the TLP Pro 725M or TLP Pro 1025M
using the RWM 2.
ATTENTION:
All structural steps and electrical installation must be performed by qualified personnel in accordance with local and
•
national building codes and electrical codes.
Toute étape structurelle et installation électrique, doit être effectuée par un personnel qualifié, conformément aux codes du
•
bâtiment, aux codes incendie et sécurité, et aux codes électriques, locaux et nationaux.
1
A A
B B
RWM 2
Figure 1.
A Screws to turn locking arm (4)
B Magnets (7*)
*The RWM 2 ships with six magnets attached to the front and a spare attached to the back, as shown in
Figure 1. The spare magnet can be moved to the front if extra support is needed.
C C D D
TOP
EU EU
MK
E E
NORTH NORTH
AMERICA AMERICA
EU EU
MK
Front View
A A
= Screw to turn locking arms (4)
B B
= Magnets (7)
C 2-gang EU junction box adaption
C C
= EU mounting holes (4)
D 1-gang MK junction box adaption
B B
F F
Back View
D D
= MK mounting holes (2)
E E
= North America mounting holes (2)
F F
= Locking arms (4)
E 1-gang North America junction box
adaptation, horizontally mounted
F Locking arms (4)
1