Nilfisk-ALTO Scrubtec R 6-71C 28C Service Manual page 90
Clarke focus ii rider 28 d base; clarke focus ii rider 34 d obc base; clarke focus ii rider 34 d base; clarke focus ii rider 28 b base; clarke focus ii rider 28 b obc base; clarke focus ii rider 28 d obc base; 56114000; 56114001; 56114002; 56114003; 56114
Table of Contents
Advertisement
Service Manual – Focus II / Scrubtec R6 Rider Autoscrubber
Replacement Notes
1. Install the drive hub (40) to the new
wheel/tire using the six socket head cap
screws (39).
2. Remove the tire pulling bolts (41) from
the drive housing.
3. Lightly install the two alignment pins
(44) into two of the threaded holes of the
gearbox output disk (43).
4. Slide the drive hub (with the new wheel/
tire) over the alignment pins.
5. Gently tap on the upper portion of the
drive hub (40) to get the wheel started
over the main bearing (42) until the
mounting screws (38) can be started in
their threads.
6. Remove the alignment pins (44), and replace them with the two remaining mounting screws (38).
7. In small increments, simultaneously tighten all four mounting screws to pull the drive hub tight to the
gearbox output disk (43).
8. Finish reassembling the machine by reversing the disassembly steps.
44
43
Wheel System, Traction
38
40
39
90
- Quick Links:
- Main Controller Error Codes
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
